banner

Charge of the Lightweight Brigade【BSLBATT】

928 Published by BSLBATT Jun 17,2019

BSLBATT LiFePO4 battery

Many of you will no doubt be aware of the enormous advantages of LiFePO4 batteries, and there is a whole bunch of information regarding BSLBATT batteries on our web site here.

We’ve been asked how to charge a lithium battery bank when the boat has been set up for Flooded, GEL, or AGM lead-acid batteries, so let’s look at some of the characteristics of LiFePO4 batteries.

BSLBATT LiFePO4 battery

LiFePO4 batteries exhibit very different charge characteristics to lead-acid types. They can accept a very high charge current, and will do so for the entirety of the charge, and then effectively switch themselves off when full.

You can see the difference well illustrated in the graph, which shows the current acceptance of a BSLBATT LiFePo4 battery and a BULLSBATTERY AGM when charged from 50% State of Charge (SOC) on a 50 amp charger. The BULLSBATTERY accepts the full 50 amps for a while before tailing off into a long acceptance phase, which is typical of lead-acid batteries, but the BSLBATT sucks in the whole 50 amps all the way until it’s fully charged.

The charge voltage of LiFePO4 batteries is not as critical as with lead-acid types and doesn’t require complex multi-step charge routines. Naturally, there is an upper voltage limit that should not be exceeded, but even a charge at 14.0v will recharge a BSLBATT 12v battery to 99%+ SOC without detriment, and LiFePo4 batteries are true Partial State Of Charge (PSOC) batteries, and do not require to be fully charged on each cycle.

For their 12v LiFePO4 batteries, BSLBATT suggest a charge voltage of 14.4v to 14.6v, which is in the range of many existing chargers and alternators set to charge lead-acid batteries. Once the charge current drops to 5% of the amp/hour capacity, i.e. 5 amps for a 100 amp/hour battery, the charge is complete and can be discontinued. If using an existing charger or inverter/charger that has a Float stage incorporated in the charge routine, as most do, then there’s no issue with leaving the Float active and set to any voltage between 13.3v and 13.8v.

You don’t have to be concerned about BSLBATT batteries being at too high or too low a voltage, or being overcharged and/or overheating, because inside that plain-looking pretty blue case is a sophisticated battery management system (BMS) linked to an array of voltage, temperature, and current sensors.

If an abnormal situation should arise, such as a faulty charger or an excessive load current or short circuit, the BMS will disconnect the battery long before any damage can be done, and then re-connect when the situation is normalized. As an additional safety measure, a fuse can be installed directly onto the battery positive post, with the fuse rating selected according to maximum expected charge and discharge currents.

Batteries for house banks on boats are commonly wired in parallel to increase capacity, and this makes for a very flexible installation. More batteries can be added at a later date if greater capacity is required, or individual batteries can be removed for whatever reason and still leave a working bank.

When a number of individual batteries are wired in parallel, the charge and load currents are shared equally, give or take an amp or two, between them. For example, a 100 amp charger will be putting around 25 amps into each battery in a four-battery bank, and although these batteries can safely take higher charge currents, low charge currents put less stress on the battery and increase the safety factor.

Charging LiFePO4 batteries like those from BSLBATT at temperatures below freezing will require some additional regulation of the maximum charge current, and details of this and maximum recommended charge currents for parallel-wired battery banks can be found in the BSLBATT Charging Instructions.

It is usually not necessary to replace a mains charger or alternator when installing BSLBATT LiFePO4 batteries to replace lead-acid types, i.e. AGM, GEL, or Flooded, but the charge settings should be checked to ensure that the voltages are within the guidelines specified by BSLBATT. Chargers set for Flooded battery types will typically be set at higher voltages than those suitable for BSLBSTT batteries, and so those should be given careful attention. Solar, wind, hydro, and other charge controllers should also be checked for compatible output voltages when charging BSLBSTT batteries.

One item that may require attention is the alternator. Standard marine alternators are not expected to deliver their maximum possible output for any length of time, yet LiFePO4 batteries will consume everything they can get in the way of charging amps for the full duration of the charge, and this could stress and overheat the alternator. There are alternator regulators available from Balmar and others that use a temperature sensor attached to the alternator case. These will reduce current output when/if the alternator gets above a certain temperature in order to prevent excessive heat and stress damaging the alternator.

So, there you have it. These are exciting times, and thanks to BSLBATT, the power, safety and convenience of a lithium battery bank is now available in standard battery case sizes, making installation a breeze.

Leave a Comment
Your email address will not be published. Required fields are marked *

Solar Street Lamp Lithium Battery | Lithium Iron Phosphate Battery Manufacturer

THE BEST LITHIUM BATTERY FOR SOLAR STREET LIGHTS BSLBATT Lithium is China’s Lithium battery m...

Do you like ? 884

Read more

One 36V Battery Or Three 12V Batteries? The Pros And Cons | BSLBATT

Years ago, when an application required 36 volts, the best option was to connect three 12V bat...

Do you like ? 957

Read more

48V Lithium-ion battery for hybrid power solutions for telecommunications and off-site sites

48V Lithium-Ion Battery for Hybrid Power Solutions of Telecoms & Off-Grid Sites BSLBATT’s...

Do you like ? 704

Read more

BSLBATT B-LFP12-100-LT Battery System Provides Reliable Power For Cold Areas In North Dakota

What is the Best Battery for Cold Weather? In order to make the most of the COVID-19 pandemic...

Do you like ? 960

Read more

BSLBATT Lithium is the new name: A high-performance energy storage systems tailored to your needs

BSLBATT Lithium launches renewable energy storage solution Economic growth and growing popula...

Do you like ? 604

Read more

Lithium-Ion Technology Poised to Change Cleaning Industry

Lithium Batteries for Floor Machines Cleaning industry professionals are always on new techno...

Do you like ? 862

Read more

Join BSLBATT’s Golf Cart Dealer Program

What Sets BSLBATT aside from the Competition? Customer Support and Superior Service. China H...

Do you like ? 1,051

Read more

BSLBATT Unveils New Lithium Forklift Battery Complete With Game-Changing Technology

For “BSLBATT” (Best Solution Lithium Battery), the world leader in lithium batter...

Do you like ? 1,088

Read more